kth_logo.gif

Article

Obtaining accurate mean velocity measurements in high Reynolds number turbulent boundary layers using Pitot probes

Authors: Bailey, S., Hultmark, M., Monty, J., Alfredsson, P.H., Chong, M., Duncan, R., Fransson, J. H. M., Hutchins, N., Marusic, I., McKeon, B. J., Nagib, H.M., Örlü, R., Segalini, A. S., Smits, A. J., Vinuesa, R.
Document Type: Article
Pubstate: Published
Journal: J. Fluid Mech.
Volume: 715   642-670
Year: 2013

Abstract

This article reports on one component of a larger study on measurement of the zeropressure-gradient turbulent flat plate boundary layer, in which a detailed investigation was conducted of the suite of corrections required for mean velocity measurements performed using Pitot tubes. In particular, the corrections for velocity shear across the tube and for blockage effects which occur when the tube is in close proximity to the wall were investigated using measurements from Pitot tubes of five different diameters, in two different facilities, and at five different Reynolds numbers ranging from Re_theta 11 100 to 67 000. Only small differences were found amongst commonly used corrections for velocity shear, but improvements were found for existing nearwall proximity corrections. Corrections for the nonlinear averaging of the velocity fluctuations were also investigated, and the results compared to hot-wire data taken as part of the same measurement campaign. The streamwise turbulence-intensity correction was found to be of comparable magnitude to that of the shear correction, and found to bring the hot-wire and Pitot results into closer agreement when applied to the data, along with the other corrections discussed and refined here.

http://dx.doi.org/10.1017/jfm.2012.538